tag:blogger.com,1999:blog-4504895563216210655.post6468338707023585386..comments2024-01-11T10:09:32.041+00:00Comments on axRap: Pretty in PinkUnknownnoreply@blogger.comBlogger4125tag:blogger.com,1999:blog-4504895563216210655.post-65547833619842550402013-03-28T20:05:32.720+00:002013-03-28T20:05:32.720+00:00Hi Mark
Thanks for that - haven't heard of Oct...Hi Mark<br />Thanks for that - haven't heard of Octoprint before... will have to get hold of a Pi now :)<br />Damianhttps://www.blogger.com/profile/08315754870866371408noreply@blogger.comtag:blogger.com,1999:blog-4504895563216210655.post-59466538217255122902013-03-28T01:30:27.828+00:002013-03-28T01:30:27.828+00:00Have a look at Octoprint (https://github.com/foose...Have a look at Octoprint (https://github.com/foosel/OctoPrint). It has webcam support, allows you to start/stop/pause, as well as preheat. It will run on Linux or a $35 Raspberry Pi.Anonymoushttps://www.blogger.com/profile/14608902470569894944noreply@blogger.comtag:blogger.com,1999:blog-4504895563216210655.post-37932981209035569242013-03-26T20:23:40.758+00:002013-03-26T20:23:40.758+00:00not yet - but have just about got botqueue working...not yet - but have just about got botqueue working, which allows for remote kill. Also keen to look at a filament feed sensor that will pause the job if the filament runs out/jams.Damianhttps://www.blogger.com/profile/08315754870866371408noreply@blogger.comtag:blogger.com,1999:blog-4504895563216210655.post-17545497305501296892013-03-26T18:50:33.945+00:002013-03-26T18:50:33.945+00:00I like the webcam idea. But do you have any way to...I like the webcam idea. But do you have any way to kill the print remotely if something goes wrong?Spencerhttps://www.blogger.com/profile/00838452895430236807noreply@blogger.com